Flat Trigger for XD MOD.2 45ACP Subcompact
Here at PistolGear, we consider this a one-part trigger job. The Freedomsmith aluminum flat face trigger simply replaces the factory curved trigger, allowing for a short and crisp trigger pull. The geometry of the trigger reduces pre-travel and over-travel, giving a better trigger feel through the entire press. The self-correcting nature of this flat trigger gives your striker fired pistol the closest feel possible to the highly coveted single action trigger pull found on 1911s.
Using factory springs during our testing, we measured a trigger pull weight (from the bottom of the trigger) to be 4.75 pounds. The pre-travel or take up is 0.180″ inches and the break is another 0.180″, giving a total trigger pull of 0.360″ with zero creep.
Note: Other than just reduced weight springs, this trigger may not work with aftermarket trigger upgrade kits. If you have already installed, or plan to install, an aftermarket trigger kit, do not purchase this item – returns are not allowed. Tuning may be required to function.
Note: Before purchasing this items, please make sure that your pistol is one of the models listed below. If you purchase this item for a gun not listed, it will not fit.
Please review the below chart for compatibility before ordering.
Made in USA.
RETURNS ARE NOT PERMITTED FOR THIS ITEM UNLESS DEEMED DEFECTIVE BY THE MANUFACTURER.
|Fit Chart (Model by Caliber)|
|XD MOD.2 3.3″ Subcompact||45ACP|
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to – www.P65Warnings.ca.gov